Hello!
You're visiting the Easy Appliance Parts site in U.S.
Would you like to shop on the Canadian site?
This part is located between the drum support rollers and idler pulley in your dryer to help prevent the parts from bumping up against the brackets they are attached to. If your dryer has a burning smell, is noisy, or will not tumble, you may need to replace the thrust washer. The washer is 3/4 inches in diameter and a is genuine OEM part. It is recommended to disconnect the power to your dryer before you start your repair.
This screw is half an inch long. It is made of metal and is intended for use with ranges, refrigerators, and washing machines.
The retaining clip goes onto the end of the roller axle and holds the rear wheel onto the axle. If the ring is broken, damaged, making noises, or will not tumble, you will need to replace it. This is a genuine OEM part and is sold individually.
This screw is sold individually.
This pump is attached to the motor and helps expel water from the washing machine. It is activated after the spin speed is maintained for a specific period of time.
Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.
This hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.
The adjustable leveling leg is used to support and keep your washer level. If your washer shakes and moves during cycles you may need to replace the leveling leg. The stop nut is included with the leveling leg. The rubber foot is not included, it must be ordered separately. Order the quantity you need as they are sold individually. This is a genuine OEM part.
This v-style drive belt is thirty-two and a half inches long and half of an inch wide.
This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.
This hose attaches to the pump to help remove the water out of the washer. 7 feet in length.
Sold Individually.
The high-pressure inlet hose washer is black in color. It is one inch in diameter, made of rubber, and used with many washing machines, refrigerators, and dishwashers. The washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged and will need to be replaced. This is a genuine OEM part and is sold individually.
This part helps stop the washer from overflowing.